Curly Secret Protein Bomb Leave-in

After washing, place a small amount of the Protein Bomb Leave-in in your palm. Rub your hands together to distribute the product evenly. Working in sections, apply the leave-in to wet or damp hair. Use your fingers or a wide-toothed comb to evenly distribute the product and enhance your natural curl pattern. Pay special attention to the lengths and ends of your hair.

If you want extra hold, apply a foam or gel over the leave-in. Allow your curls to air dry naturally for softer, bouncy results. For extra volume and definition, you can use a diffuser on a low temperature setting. Once your hair is dry, if desired, you can gently scrunch your curls to break up any 'cast' and reveal soft, defined curls.

Note: For best results, use in combination with other Curly Secret products. Adjust the amount based on the length and thickness of your hair.

Aqua, Hydrolyzed Corn Starch, Cetearyl Alcohol, Simmondsia Chinensis Seed Oil, Butyrospermum Parkii Butter, Polyquaternium-37, Panthenol, Behentrimonium Chloride, Macadamia Integrifolia Seed Oil, Cannabis Sativa Seed Oil, Cetrimonium Chloride, Persea Gratissima Oil, Benzyl Alcohol, Dipropylene Glycol, Perfume, Sodium Benzoate, Hydroxypropyl Guar Hydroxypropyltrimonium Chloride, Propylene Glycol, Aleurites Moluccanus Seed Oil, Cocodimonium Hydroxypropyl Hydrolyzed Rice Protein, Citric Acid, Hydrolyzed Quinoa, Dehydroacetic Acid, Sodium Hydroxide, Arctium Lappa Root Extract, Potassium Sorbate

This is how you use a leave-in conditioner , detangler or heat-UV spray in your curls routine:

1. On damp hair after washing: Apply the pre-styler to towel-dried hair, immediately after rinsing yourconditioner or mask . Make sure your hair is thoroughly damp.
2. Focus on the lengths and ends: When applying the product, concentrate mainly on the lengths and ends of your hair, where it is often the most dry and damaged.
3. Comb through: Use a comb or brush to distribute the pre-styler conditioner evenly through your hair and remove any tangles.
4. Leave in the hair: Do not rinse the pre-stylers, but leave them in your hair to provide long-lasting hydration and care.

Heat & UV sprays

Heat protectors can be applied in different ways. As a pre-styler but also after styling. Consult the instructions for use with the product to see if you can use the above steps.

Additional Tips:

1. Fine, thin hair or strands : Use a cream / activator or opt for a leave-in conditioner. Both products may be too heavy to use together. Then apply a gel or other styler for extra curl definition.

The next step for your curl routine:

After this step, apply styling products such as gel , mousse , or cream after the leave-in conditioner or other pre-styler to define and protect your curls.